Hitec X1 Pro 180w RC LiPo / LiFe / NiMH /NiCd/Pb DC RC Battery Charger 44215

Description

This Is Hitec X1 Pro DC Battery Charger .
This Is DC Charger If You Want Used For AC , You Need Your Own Power Supply To Works . Thanks
FEATURES
Charges 1-6 cell LiPo, LiFe & LiIon batteries
1-15 cell NiMH NiCd batteries
2-20V lead acid (Pb) cells
180W charging circuit
Adjustable charge current rate of 0.1-16 amps
Fast and storage charge modes for lithium batteries
Balances individual cells during discharging
Re-peak mode and delta peak sensitivity for NiMH and NiCd batteries
Hitec Charge Master software allows control of charger through a
computer
Blue LCD backlight display
Docking capability with the Hitec ePowerBox 17A power supply
Single port output
One year limited warranty through Hitec beginning at date of
purchase when purchased and used in the USA, Canada or Mexico
INCLUDES
Hitec X1 Pro DC Powered Battery Charger, 2-6S Balance Board, Balance
Adapter, 12AWG DC Input Power Cable with XT60 Plug, 18AWG Wire
Charging Cable, 2S Hardcase LiPo Charging Lead, Instruction
Manual
REQUIREMENTS
DC power source such as the Hitec ePowerBox 17A power supply,
HRCP4216
SPECIFICATIONS
Input Voltage Range:
11-18V DC
Charge Circuit Power:
180 watts
Discharge Circuit Power:
30 watts
Charge Current Range:
0.1-16 amps
Discharge Current Range:
0.1-8.0 amps
LiPo, LiFe & LiIon Balancing Current Drain:
200mA per cell
LiPo, LiFe & LiIon Cell Count:
1-6 cell
Maximum NiCd/NiMh Cell Count:
1-15 cells
Lead Acid (Pb) Cells / Voltage:
2-20 V
Dimensions:
3.6 x 4.4 x 2.0" (91 x 112 x 51mm)
Weight:
14.3oz (405g)
How To Calculate Your Charging Needs
To determine if this charger is suitable for your application, you must perform this calculation to determine the maximum amp rate the charger can supply. Divide the Watts of the charger by the Voltage of the battery pack. This will tell you the maximum amp rate the charger can deliver (Watts / Voltage = Amps). For example, if using the Touch 625 AC and a 6S LiPo battery, you would divide 200 Watts by 22.2 Volts to realize a 9 Amp charge rate. This means that the charger can supply a maximum of 9 amps to a 22.2 Volt 6S battery. This amp rate will gradually reduce as the battery voltage increases during the charge cycle.
LiPo Battery & Charger Warnings:
1)
DO NOT
leave the battery in your model when charging
2)
DO NOT
leave unattended when charging
3)
ALWAYS
balance charge the battery
4)
ALWAYS
use a LiPo charging bag
5)
YOU MUST
use a Li-Poly specific charger to charge the pack (NiMH or NiCd only chargers WILL NOT WORK!)
6)
YOU MUST
not over discharge the Li-Poly battery pack
7)
READ & UNDERSTAND
the instructions carefully before operating this battery
WARNING NOTE:
This charger is not recommended for use with Traxxas batteries with ID connectors or Spektrum Smart batteries with IC connectors. Charging batteries equipped with ID or IC connectors may require additional steps in order to safely balance charge your Lipo batteries. Please refer to your vehicle or aircraft owner’s manual for recommended batteries and charging equipment.